Tuner Operation - Goodmans MICRO1103 Instruction Manual

REPEAT PLAY
To listen to a disc or track over and
over again.
1. Press M-UP/REPEAT.
2. "REPEAT" will illuminates in the
display. The whole disc will be
repeated.
3. Press M-UP/REPEAT again,
"REPEAT" will flash in the dis-
play. The current track will be
repeated.
4. Press M-UP/REPEAT until
"REPEAT" disapears from display
to cancel the repeat function.
DISPLAY FUNCTION
In Radio Mode:
Press DISPLAY/REMAIN to change
display information as follows:
Frequency display > Clock dis-
play > Timer ON time (Frequency
display)
In CD Mode:
Press DISPLAY/REMAIN to
change display information as
follows: Elapsed time > remain-
ing time > Clock display > Timer
ON time (CD normal display)
- Random Play:
Elapsed time remaining time >
Clock display > Timer ON time
- Memory Play:
Elapsed time remaining time >
Remain > Clock display > Timer
ON time.
HELPLINE PHONE NUMBER 0870 873 0080
13
In Other Mode:
Press MODE/REMAIN to change
display information as follows:
Clock display > Timer ON (Clock
display)
Important note:
Please ensure that small
children/babies do not operate
this appliance. keep them away
from the motorized CD tray as
trapped fingers may hurt.

TUNER OPERATION

TUNING
1. Press POWER to switch on
the unit.
2. Press "TUNER" button to
select tuner.
3. Select the required waveband
by pressing the STOP/BAND
button.
4. Press UP/FF or DOWN/
F F F F F
REW for few seconds, then
B B B B B
release.
– The tuner will automatically
search for the first transmitter
of sufficient strength.
– Repeat this procedure if you
wish to select another station.
5. To tune to weak stations,
briefly press UP/FF or
F F F F F
DOWN/ REW repeatedly
B B B B B
until the correct frequency is
found.
6. If there is a large amount of
interference(noise)move the
STEREO/MONO switch to the
mono position.
PROGRAMMING OF PRESET
STATIONS
1. Press "TUNER" button to
select tuner.
2. Tune to the desired station as
described under Tuning.
3. Press PROG/MEM(on remote).
"MEMORY" will start to flash
and channel "00" will displayed.
4. Press M-up to assign a number
(1-10) to the preset station.
5. Press PROG/MEM (on remote)
again. The frequency, and
preset number are now
entered in the memory.
HELPLINE PHONE NUMBER 0870 873 0080
14
6. Repeat this procedure to store
other frequencies and preset
in the memory.
TUNING TO PRESET STATIONS
Select a number between 1 and
10 by pressing: M-UP/REPEAT
button.