Not Oracle Certified Dimm Warning Message (Cr 7034912); System Firmware Issues; Link Width X8 Link Speed Gen1 Warning Displayed During Power Up (Cr 6958263) - Sun Oracle Netra SPARC T3-1B Product Notes

Not Oracle Certified DIMM Warning
Message (CR 7034912)
After installing supported optional component DIMMs shipped from Oracle
Corporation or from a certified Oracle reseller, or after replacing a failed DIMM with
a FRU DIMM, you might see warning messages similar to the following:
[CPU 0:0:0:] WARNING: /SYS/MB/CMP0/BOB0//CH0/D0:
Not Oracle Certified
The system displays these messages because optional component and FRU DIMMs
have not been marked as certified. Oracle certifies only DIMMs that ship installed in
a system from the factory. Although Oracle has not certified these DIMMs, they are
still supported. You can safely ignore these warning messages.

System Firmware Issues

Link Width x8 Link Speed GEN1 Warning
Displayed During Power Up (CR 6958263)
This is fixed in SysFW 8.0.4.c and higher.
On rare occasions while powering up the server module, the following error
message might be displayed just before the system reaches the OBP prompt:
WARNING: ios0, peun Link Width x8 Link Speed GEN1.
Workaround: Reset the system at the OBP prompt.
ok reset-all
Chapter 2 Late-Breaking Information 11