Oracle Solaris Jumpstart Example; Interactive Installation Example - Sun Oracle Netra SPARC T3-1B Product Notes

/pci@400/pci@1/pci@0/pci@2/LSI,sas@0
MPT Version 2.00, Firmware Version 4.05.52.00
Target 9
Unit 0 Disk
SASDeviceName 5000c500231694cf
Target a
Unit 0 Disk
SASDeviceName 5000c50003d37fcb

Oracle Solaris Jumpstart Example

This Oracle Solaris Jumpstart profile example shows how to use the WWID syntax
when installing the OS on a specific disk drive. The SASDeviceName is taken from
the previous configuration listing.
Note – The Oracle Solaris syntax rules require all alpha characters to be capitalized.
#
install_type flash_install
boot_device c0t5000C500231694CFd0 preserve
archive_location nfs
129.148.94.249:/export/install/media/solaris/builds/s10u9/flar/latest.flar
# Disk layouts
#
partitioning explicit
filesys rootdisk.s0 -----------free /
filesys rootdisk.s1 -----------8192 swap

Interactive Installation Example

In an interactive installation, you are asked to specify one or more disks as the
targets for the OS installation. The purpose of this step is to ensure that enough disk
capacity is provided for the installation. For this step, specify the disk with the
WWID value corresponding to the drive on which you want to install the software.
These WWID values are illustrated in the following interactive example,. The drive
selected as the install target is located in HDD slot 0, the default OBP location.
SEAGATE ST930003SSUN300G0868
SASAddress 5000c500231694cd
SEAGATE ST973402SSUN72G 0603
SASAddress 5000c50003d37fc9
<===== SAS Controller
585937500 Blocks, 300 GB
143374738 Blocks, 73 GB
Chapter 1
PhyNum 0
PhyNum 1
General Information 7