Cleaning Equipment After Installation - Aquacal TropiCool TC500 Installation Manual

CHEMICAL
Total
Alkalinity
Calcium
Hardness
Total
Dissolved
•
Solids
•
Salt from a chlorine generator is not included in Total Dissolved Solids.

5.2 Cleaning Equipment After Installation

Installer - If you need to clean equipment after installation, please use the following guidelines.
WARNING - Failure to heed the following may result in injury or death.
Possible electric shock hazard - Deactivate power to all electrical devices on the pad when washing chiller. Do
l
not restore electrical power until equipment is completely dry.
CAUTION - Failure to heed the following may result in equipment damage.
Do not use a pressure cleaner to wash chiller. Damage to chiller components may result. If using a hose-end
l
spray nozzle adjust spray pattern to low strength only.
Do not spray water directly into the interior of the chiller; damage to components may result.
l
Do not use chemicals on the control panel.
l
Cleaning
1. Wash outside cabinet using a low-pressure water hose. A high-pressure water stream will cause damage to the
aluminum fins of the chiller This damage is not covered under product warranty.
2. While the chiller is still wet, use an approved cleaning agent to clean the exterior of the chiller. Do not use
chemicals on the control panel.
3. Use a detergent-dampened cloth to wipe the chiller's exterior cabinet.
4. Flush all exterior with fresh water using a low-pressure water hose.
5. Dry the exterior cabinet using a soft cloth being careful not to damage condenser fins.
APPROVED CLEANING AGENTS
®
Fantastic
®
Formula 409
®
Cascade
All Power Plain Detergent (3% Solution)
Table 4 - Cleaning Agents
Polishing
1. Polish the chiller's cabinet panels using an approved polishing agent and following the manufacturer's
instructions. Do not use chemicals on the control panel.
2. Rinse the chiller panels with fresh water, wipe, and buff panels using a dry soft cloth.
3. Allow chiller interior and surrounding equipment to "air-dry" for several hours prior to restoring electrical
power.
CHEMISTRY LEVEL CHART
(RESIDENTIAL)
POOLS
80 – 120 ppm 80 – 120 ppm
200 – 400
150 – 250 ppm
ppm
1,500 ppm above start-up total dissolved solids in
0 – 1,500 ppm
spas
•
SPAS
Page - 18