Aquacal TropiCool TC500 Quick Start Manual
Hide thumbs
Also See for TropiCool TC500:
- Installation manual (35 pages) ,
- Operation manual (27 pages) ,
- Brochure & specs (2 pages)
Related Manuals for Aquacal TropiCool TC500
Summary of Contents for Aquacal TropiCool TC500
-
Page 1: Quick Start Guide
Quick Start Guide Models: TC500 & TC1000 For product manuals and further installation / operation procedures visit www.AquaCal.com Important Read This Guide Before Installing or Operating Water Chiller LTP0094 Rev-1 03/31/2014... -
Page 2: Section 1 - General Information Contacting Aquacal Autopilot
Phone 8:00 a.m. to 5:00 p.m. Eastern time, Monday through Friday (727) 821-7471 Please have your model and serial numbers available when contacting AquaCal AutoPilot for questions, service, or parts. SAFETY For personal safety, and to avoid damage to equipment, follow all safety instructions displayed in this guide. Repair and service of your water chiller must be performed by qualified service personnel. -
Page 3: Section 2 - Installation
Page 2 SECTION 2 - INSTALLATION For commercial or complete installation instructions please, visit www.AquaCal.com for equipment manual. EQUIPMENT CLEARANCES Keep the area immediately adjacent to the water chiller clear of items such as shrubs and bushes, lawn furniture, chemicals containers, etc. These items can prevent air from circulating properly through the water chiller, and will result in inefficient operation and/or damage. -
Page 4: Section 3 - Operation
“000” “MODE” to temporarily unlock water chiller. If code is unknown, a re- activated. set option is available in product manual. Manuals can be downloaded from www.AquaCal.com. “COO” Cooling Mode Water chiller is set to cool the water. This mode is for units that heat water and is not intended for use with “ACH”... -
Page 5: Section 4 - Maintenance
Page 4 PROGRAMMING Activity Steps Step 1: Select the “POOL / SPA” button to choose the thermostat to adjust. Step 2: Select the “UP” or “DOWN” button to increase or decrease the desired set temperature. Adjusting Step 3: Once set, the current water temperature will be displayed. The water chiller will start to operate to meet Temperature the desired temperature. -
Page 6: Section 5 - Troubleshooting
Page 5 SECTION 5 - TROUBLESHOOTING ERROR CODES SYMPTOM RULE OUT RESOLUTION "FLO" Insufficient water flow through Step 1: Insufficient Water water chiller or circulation Confirm water pump is on and water valves are in the correct position to allow Flow pump is off water to flow through water chiller.