Cleaning Equipment After Installation - Aquacal TropiCool TC500 Installation Manual

Reset to Factory Defaults Settings
NOTICE
Using this option will reset ALL settings to their factory defaults including external controller settings
l
and sensor calibrations. DO NOT perform this operation if unsure of site specific settings or how to
reset them on the chiller.
If a qualified technician is unavailable, please see "Contacting AquaCal AutoPilot, Inc." on page 1.
l
1. Simultaneously Press "Pool / Spa" button and "Up" button
until the display shows 888 .
2. Release buttons. Reset is complete.

1.7 Cleaning Equipment After Installation

Installer - If you need to clean equipment after installation, please use the following guidelines.
WARNING
Possible electric shock hazard - Deactivate power to all electrical devices on the pad when washing chiller. Do not
l
restore electrical power until equipment is completely dry.
NOTICE
Do not use a pressure cleaner to wash chiller. Damage to chiller components may result. If using a hose-end spray
l
nozzle adjust spray pattern to low strength only.
Do not spray water directly into the interior of the chiller; damage to components may result.
l
Do not use chemicals on the display panel.
l
Cleaning
1. Wash outside cabinet using a low-pressure water hose. A high-pressure water stream will cause damage to the
aluminum fins of the chiller. This damage is not covered under product warranty.
2. While the chiller is still wet, use an approved cleaning agent to clean the exterior of the chiller. Do not use
chemicals on the display panel.
3. Use a detergent-dampened cloth to wipe the chiller's exterior cabinet.
4. Flush all exterior with fresh water using a low-pressure water hose.
5. Dry the exterior cabinet using a soft cloth being careful not to damage evaporator fins being careful not to damage
condenser fins.
APPROVED CLEANING AGENTS
®
Fantastic
Formula 409 ®
®
Cascade
All Power Plain Detergent (3% Solution)
Table 3 - Cleaning Agents
Page - 23
Failure to heed the following may result in damage to equipment.
Failure to heed the following may result in injury or death.
Failure to heed the following may result in damage to equipment.
•