Advertisement
17
PROCEED TO THE NEXT PAGE FOR INSTRUCTIONS ON OPERATION AND MAINTENANCE
ALL JOINTS AND CONNECTIONS MUST NOW BE LEAK TESTED BEFORE USING THE BARBECUE.
Leak test annually, and whenever the gas bottle is removed or replaced.
LEAK TESTING
Always perform a leak test in a well-ventilated area.
Step 1 - Confirm all control knobs are in the off position.
Step 2 - Turn the gas on / open the gas control valve on the gas bottle or regulator.
Step 3 - Through the gap on the underside of the control panel, check for leaks by brushing a solution of
½ water and ½ liquid detergent / soap over all the gas system joints, including all valve connections,
hose connections, and regulator connections.
Step 4 - NEVER USE AN OPEN FLAME to test for leaks at any time.
Step 5 - If bubbles form over any of the joints there is a leak
Turn off the gas supply at the gas bottle
Retighten all joints
Repeat test
If bubbles form again do not use the barbecue and contact your local Outback distributor for
assistance.
Always wipe the mixed solution (½ water and ½ liquid detergent / soap) from all joints and connections
after leak testing.
LEAK TEST DIAGRAM
1. Maximum diameter or breadth is 320mm.
2. Maximum height (regulator included) is 600mm.
ASSEMBLY IS NOW COMPLETE.
2
1
Advertisement
