Fuji Xerox DocuPrint P455 d User Manual page 176

• IEEE 802.1x
NOTE:
• IEEE 802.1x feature is available only when the printer is connected using LAN cable and the IEEE 802.1x authentication is
enabled using CentreWare Internet Services. For details about setting IEEE 802.1x, see the Help on the CentreWare Internet
Services.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on
again.
Value:
Disable
• Initialize NVM
Purpose:
To initialize wired and wireless network data stored in non-volatile memory (NVM). After executing this function and
rebooting the printer, all wired and wireless network settings are reset to their default values.
• Adobe Protocol
Purpose:
To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol settings
for the wired network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto*
Standard
BCP
TBCP
Binary
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Port Status
NOTE:
• Port Status feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Values:
Disable
*
Enable
176
Using the Operator Panel Menus
Disables IEEE 802.1x.
Sets the PostScript communications protocol automatically.
Sets the PostScript communications protocol to Standard.
Sets the PostScript communications protocol to BCP.
Sets the PostScript communications protocol to TBCP.
Sets the PostScript communications protocol to Binary.
Disables the USB port.
Enables the USB port.