Fuji Xerox DocuPrint P455 d User Manual page 110

Operator Panel
Auto SSID Setup
1
Press the (Menu) button.
2
Select Admin Menu, and then press the
3
Select Network Setup, and then press the
4
Select Wireless Setup, and then press the
The printer automatically searches the access points on wireless network.
5
Select the desired access point, and then press the
If the desired access point does not appear, go to
NOTE:
• Some hidden SSID may not be displayed. If the SSID is not detected, turn on SSID broadcast from the router.
6
Enter the WEP key or pass phrase, and then press the
The Restart Printer to apply setting message appears.
7
Turn off the printer, and turn it on again to apply the settings.
Wireless settings are correctly configured.
IMPORTANT:
• If the optional hard disk unit is not installed on your printer, note that the data in the memory are cleared when the printer
is turned off.
Manual SSID Setup
1
Press the (Menu) button.
2
Select Admin Menu, and then press the
3
Select Network Setup, and then press the
4
Select Wireless Setup, and then press the
5
Select Manual Setup, and then press the
6
Enter the SSID, and then press the
7
Select the network mode from Infrastructure or Ad-hoc depending on your environment, and then press
the button.
When you select Infrastructure, proceed to step 8.
When you select Ad-hoc, proceed to step 9.
8
Select the encryption method from Mixed mode PSK, WPA-PSK-TKIP, WPA2-PSK-AES, or WEP, and then
press the button.
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
To use Mixed mode PSK, WPA-PSK-TKIP, or WPA2-PSK-AES encryption:
Select the desired encryption method.
a
Enter the pass phrase, and then press the
b
The Restart Printer to apply setting message appears.
To use WEP encryption:
Select WEP for the encryption method, and then press the
a
110
Printer Connection and Software Installation
button.
button.
button.
button.
"Manual SSID Setup" on page
button.
button.
button.
button.
button.
button.
button.
110.
button.