Table of Contents
Advertisement
01P
FINAL DRIVE FLUID CAPACITY
Application
01P
DRAINING & REFILLING
1. To replace ATF, raise and support vehicle. Place drip tray under the transaxle. Remove ATF level
plug from the oil pan. See Fig. 2 . Remove overflow pipe through the level hole. Drain ATF. Install
overflow pipe. Screw level plug in hand-tight.
2. Fill with appropriate amount of ATF through filler pipe using VAG 1924 ATF filling system. See
FLUID CAPACITIES . See Fig. 5 . Start engine and shift transaxle through all the selector lever
positions with the vehicle stationary. Check and top off ATF level. See CHECKING FLUID
LEVELS . Tighten ATF level plug to 11 ft. lbs. (15 N.m).
ON-VEHICLE REPAIRS
NOTE:
Various components may be serviced without transaxle removal. For
servicing of these components, see appropriate component under
ADJUSTMENTS and/or REMOVAL & INSTALLATION .
ADJUSTMENTS
SELECTOR LEVER CABLE
Checking & Adjusting
NOTE:
In the following procedures, numbers in parenthesis are shown in
illustrations.
1. Remove selector lever cable locking washer (6) from lever/selector shaft. See Fig. 7 . Take selector
lever cable off lever. Move selector lever from "P" to "1" position. Selector lever mechanism and
selector lever cable must move freely. If necessary, replace selector lever cable or service selector
lever mechanism. Always replace selector lever cable locking washer on transaxle support bracket
after disassembling.
2. To adjust cable, place selector lever in "P" position. Loosen adjustment bolt (2) on selector lever in
selector lever housing. See Fig. 8 . Place selector shaft lever in "P" position on transaxle. Locking
lever must engage in park lock wheel, with both front wheels locked. Tighten adjustment bolt on
selector lever in selector lever housing to 15 ft. lbs. (20 N.m).
4 января 2005 г. 1:05:10
2003 Volkswagen EuroVan MV
SERVICING - A/T
3.2 (3.0)
Page 8
5.6 (5.3)
Qts. (L)
.8 (.75)
© 2004 Mitchell Repair Information Company, LLC.
Hide quick links:
Advertisement
Table of Contents
