Table of Contents
Advertisement
LOCKING CABLE
Removal & Installation
NOTE:
In the following procedures, numbers in parenthesis are shown in
illustration.
1.
NOTE:
When battery is disconnected, vehicle computer and memory systems
may lose memory data. Driveability problems may exist until computer
systems have completed a relearn cycle.
CAUTION:
Radio/cassette or radio/CD player is equipped with an anti-theft
protection circuit. Whenever battery is disconnected, radio will go into
anti-theft mode. When battery is reconnected, radio will display CODE,
and will be inoperative until proper code number is entered. Obtain
security code before disconnecting battery.
Place selector lever in "P" position. Obtain radio security code (if equipped). Disconnect negative
battery cable. Remove selector lever handle, trim, cover, cover strips and selector lever console. See
Fig. 7 .
2. Remove locking cable from frame and take off from locking lever ball head. Remove ignition switch
trim. Press locking cable clip (4) out of ignition switch support and remove locking cable (2) from ball
head. See Fig. 10 . Remove footwell vent console. Take out locking cable.
3. To install, reverse removal procedure. Ensure proper routing of locking cable when installing. Adjust
locking cable after installation. See LOCKING CABLE under ADJUSTMENTS.
4 января 2005 г. 1:05:11
2003 Volkswagen EuroVan MV
SERVICING - A/T
Page 12
© 2004 Mitchell Repair Information Company, LLC.
Hide quick links:
Advertisement
Table of Contents
