Initial Start Up; Care & Maintenance - Westinghouse FJ302 User Manual

INITIAL START-Up
IcE MAKER START Up
If the ice maker is not connected to a water supply, ensure
that the ice maker is turned off. To do this, remove the
ice bucket by lifting it up and out then check that the wire
signal arm is in the horizontal (OFF) position. If not, raise
the wire signal arm so that it stays in the horizontal position.
NOTE: The arm will not stay up if it is not horizontal.
If the ice maker is connected to a water supply, ensure
that the ice maker is turned on. To do this, remove the ice
bucket by lifting it up and out then lower the wire signal
arm down to the ON position.
WARNING
D o not use the ice chute as a handle when removing or
replacing the ice storage bin.
Do not put fingers up the ice chute. Surfaces there may be
sharp.
cARE & MAINTENANcE
cLEANING THE IcE DISpENSER
Clean the dispenser and ice container at regular intervals,
particularly before you take a vacation or move, also clean
the dispenser if it sticks.
To clean the dispenser:
1. Switch the ice maker off by putting the wire signal arm
in the horizontal position.
2. Remove the ice container by lifting it up and
out. Empty and carefully clean the container with
mild detergent. Rinse carefully ensuring no traces
of detergent remain. Do not use harsh or abrasive
cleaners. Allow the ice container to dry completely
before replacing it in the freezer.
3. Remove ice chips from the shelf and chute that support
ice off position
the ice container; clean these areas.
4. Replace the ice container.
5. Turn the ice maker on by moving the wire signal arm.
ice on position
When removing or replacing the ice bin do not rotate the
auger in the ice bin. If the auger is accidentally turned, you
must realign the auger by turning it in 90 turns until the ice
bin fits into place with the drive mechanism
ReMOve AND eMpTy THe ICe STORAGe BIN IF:
1. An extended power failure (one hour or longer) causes
ice cubes in the ice storage bin to melt and freeze
together and jam the dispenser mechanism.
2. If the ice dispenser is not used frequently, ice cubes
will freeze together in the bin and jam the dispenser
mechanism. If this happens remove the ice storage bin
and shake it to loosen
the cubes.
NEVER use an ice pick or similar sharp instrument to
break up the ice. This could damage the ice storage
bin and dispenser mechanism.
CAUTION
2