Classic Side By Side; Installation - Westinghouse FJ302 User Manual

cLASSIc SIDE bY SIDE

GENERAL INSTALLATION
ADjUSTING THE ROLLERS
To adjust the rollers you must first remove the air grille by
rotating it upwards
Pull the air grille forward to disengage the spring steel clips
that mount the air grille to the refrigerator. You will then
be able to see the roller nut and adjust the rollers as per
instructions on page 5.
Once the refrigerator is level and the doors are aligned,
refit
the air grille:
• line the spring clips up with the slots at the base of
the refrigerator
• to ensure that the grille is in position, strike it firmly with
your hand to fully engage the steel spring clips
.
IcE AND wATER MODELS
The water connection to your ice and water product should
only be done by a licensed refrigeration mechanic, plumber
or electrician. All relevant information regarding the water
connection is detailed in the water kit provided with your
product for use by the professional installer only.
WARNING
Connect to potable water supply only.
The automatic ice and water dispenser needs a drinkable
water supply with a pressure of:
• minimum 206 kPa (30 psi, 2.11 kgf/cm³)
• maximum 689 kPa (100 psi, 7.04 kgf/cm³)
In some areas local water pressure is significantly higher
due to local conditions. In such areas a pressure reducing
valve must be used. Ensure your plumber or installer checks
your local water pressure when installing your refrigerator.
If you are using your refrigerator for the first time, or if you
have not used the dispenser for some time:
• discard the first seven or eight cups of water
• discard any ice that the ice maker produces in the
first 24 hours (contaminants could have settled in the
water pipes)
The water tap can be anywhere and there is no limit to the
amount
of pipe between the tap and the refrigerator, however some
points
to note are:
1. It is better to have the tap accesible without having to
roll the refrigerator forward, so we recommend putting
it outside the cavity as shown by the stars in the
diagram below.
2. The height of the tap does not matter, but for new
installations, position it 400mm from the ground.
3. If the refrigerator is required to be pulled forward for
cleaning, the water pipe may need to be removed from
the tap.