Initial Start-Up - Fridge; Manual Controls; Controlling The Temperature - Westinghouse WRM2400 User Manual

INITIAL START-UP – FRIDGE
This series of refrigerators has been fitted with a 'wet
wall' evaporator which is positioned behind the rear liner.
The rear liner will, at times be wet or appear frosted.
This is normal and demonstrates that the refrigerator is
functioning correctly. This product is designed to operate
on a power supply of 220/240 volts 50Hz. Connect to a
separate power point with a correctly earthed three pin
socket. Do not use double adaptors.
Controlling the temperature in your refrigerator
Refrigerators work by transferring heat from the food
inside to the outside air. This operation makes the back
and sides of the refrigerator (particularly at start-up)
feel warm – which is normal. Make sure you fully close
the refrigerator door after loading or removing food. If
the door is left partially open, a heavy frost will coat the
inside of the ice box. Ensure shelves are pushed back
completely to prevent them holding the door open.
If the unit is unplugged, power lost or turned off, you
must wait 3 to 5 minutes before restarting the unit. If
you attempt to restart the unit before this time delay, the
refrigerator will not start.
When the thermostat is turned to it's lowest setting
and past the point of resistance, the appliance will not
operate.
WARNING
WARNING
Power is still supplied to the appliance.
This series of refrigerator has been fitted with a hidden
"wet wall" cooling plate, which is positioned behind
the rear liner wall of the food compartment.
The rear liner may, at times, appear frosty or wet.
This is normal and demonstrates that the refrigerator
is functioning correctly.
Condensation caused
by the cooling plate
10
INITIAL START-UP
Turn the control knob clockwise to turn the appliance on.
Rotating clockwise will make the appliance colder.
For all models, 'Less Cold' corresponds to the warmest
temperature while 'Colder' the coldest.
Adjusting the control knobs of WIM1000 amd WIM1200
will adjust the temperature in both the fridge and freezer
compartments.
When the ambient room temperature is 16°C, a setting
of half way between 'Less Cold' and 'Off' recommended.
When the ambient room temperature is 25°C, a setting
of half way between 'Off' and 'Colder' recommended.
WRM2400
Less Cold
Off
WIM1000
When you change temperature settings, make small
adjustments and wait 24 hours before assessing whether
you need to make further changes.
Bulb (inside)
Lampshade
WIM1200 and WIM1400
Less Cold
Off
Colder
Colder
Thermostat knob