Compact Side By Side; Ice & Water Installation - Westinghouse FJ302 User Manual

cOMpAcT SIDE bY SIDE

INSTALLING IcE & wATER MODELS
IcE AND wATER MODELS
The water connection to your ice and water product
should only be done by a licensed refrigeration mechanic,
plumber or electrician. All relevant information regarding
the water connection is detailed in the water kit provided
with your product for use by the professional installer only.
The automatic ice and water dispenser needs a drinkable
water supply with a pressure of:
• minimum 206 kPa (30 psi, 2.11 kgf/cm²)
• maximum 689 kPa (100 psi, 7.04 kgf/cm²)
In some areas local water pressure is significantly higher
due to local conditions. In such areas a pressure reducing
valve must be used. Ensure your plumber or installer checks
your local water pressure when installing your refrigerator.
If you are using your refrigerator for the first time, or if you
have not used the dispenser for some time:
• discard the first seven or eight cups of water
• discard any ice that the ice maker produces in the
first 24 hours (contaminants could have settled in the
water pipes)
The water tap can be anywhere and there is no limit to
the amount of pipe between the tap and the refrigerator,
however, some points to note are:
1. It is better to have the tap accessible without having to
roll the refrigerator forward, so we recommend putting it
outside the cavity as shown by the stars in the diagram
below.
2. It is recommended that the height of the tap should be
400mm from the ground.
3. If the refrigerator is required to be pulled forward for
cleaning, the water pipe may need to be removed from
the tap.
IcE MAKER START Up
The water connection to your ice and water product
should only be done by a licensed refrigeration mechanic,
plumber or electrician.
If the ice maker is not connected to a water supply, check
that the ice maker is turned off. To do this remove the
ice cream shelf and put the switch in the 'OFF' position.
If you don't do this a loud buzzing noise will be heard
intermittently if the icemaker is on but no water is being
supplied.If the ice maker is connected to a water supply,
check that the ice maker is turned on. To do this put the
switch in the 'ON' position.
INITIAL START Up
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SEC.
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SEC.
WARNING
Connect to potable water supply only.
Do not use the ice chute as a handle when removing
or replacing the ice storage bin.
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SEC.
Do not put fingers up the ice chute. Surfaces there may
be sharp.
cHANGING THE wATER FILTER
If you purchased a refrigerator with an ice and water filter,
please read the following care and use information.
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SEC.
OFF
ON
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SEC.