Table of Contents
Advertisement
Outputs the signal that is input to the SDI 1 IN
connector when the SDI 1 IN connector signal is
displayed.
The to connectors output the signal that is input
to the corresponding SDI IN connector.
Outputs the signal that is input to the SDI 2 IN
connector when the SDI 2 IN connector signal is
displayed.
The to connectors output the signal that is input
to the corresponding SDI IN connector.
Outputs the signal that is input to the SDI 1/2 IN
connector when the signal that is input to the HDMI IN
connector is displayed.
Note
SDI output is only activated when the power is on.
HDMI IN (HDMI input) connector
Input connector for HDMI
HDMI (High-Definition Multimedia Interface) is an
interface that supports both video and audio on a single
digital connection, allowing you to enjoy high quality
digital picture and sound. The HDMI specification
supports HDCP (High-bandwidth Digital Content
Protection), a copy protection technology that
incorporates coding technology for digital video signals.
1) The terms HDMI and HDMI High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing LLC in the
United States and other countries.
Note
To input the HDMI signal equivalent to 4K, use an
HDMI cable bearing the Premium High Speed logo
within a length of 3 meters.
To input other signals, we recommend using a Premium
High Speed HDMI cable within a length of 3 meters.
SDI 2 IN (SDI 2 input) connectors (BNC)
Input connectors for serial digital signals.
For details, see "Connecting the SDI Signals" (page 39).
SDI 2 OUT (SDI 2 output) connectors (BNC)
Output connectors for serial digital signals.
The to connectors output the signal that is input
to the corresponding SDI 2 IN connector.
Note
SDI output is only activated when the power is on.
AC IN socket
Connect the supplied AC power cord.
1)
signals.
Attaching the Monitor
Stand
1
Place the monitor facing down on a soft cloth.
2
Attach the monitor stand with the supplied screws.
Monitor stand
(supplied)
Screws (supplied)
Notes
Make sure to tighten the screws using the screwdriver
which conforms to the supplied screws.
When using an electric screwdriver, set the torque
setting to approximately 1.2 N·m [12 kgf·cm].
The Monitor stand has a front and back direction.
Attach the monitor stand so that the protrusion of the
monitor stand faces the back side of the monitor as
shown in the figure.
Rear panel of the monitor
Protrusion
19
Attaching the Monitor Stand
Advertisement
Table of Contents
