Table of Contents
Advertisement
Submenu
Setting
[Screen Saver]
Sets the screen saver function [On] or
[Off].
[On]: If a still image is displayed for
more than 10 minutes, the
brightness of the screen is
automatically decreased to
reduce burn-in. The screen
returns to normal brightness
when you input a video signal to
the unit or operate the buttons
on the side panel of the unit.
While the screen saver is active,
the STATUS indicator flashes
every two seconds. Before the
screen saver starts up, the
STATUS indicator flashes every
second to notify users that the
screen saver will start up.
[Off]: The screen saver function is
deactivated.
Note
In the HDR display, this setting is
forcibly set to [On].
For details on the HDR (High Dynamic
Range) display, see page 29.
[Power On Setting]
Sets this unit's setting status after the
unit is turned on. Select from [Last
Memory], [User Preset1], [User
Preset2], [User Preset3], [User Preset4],
[User Preset5] or [User Preset XYZ].
[Panel Calibration]
Select to adjust the uniformity of the
screen.
When selected, the confirmation screen
is displayed. Select [Confirm] to
perform Panel Calibration and select
[Cancel] to cancel Panel Calibration.
When the CALIBR. button on the
monitor or the 0 button on the Sony
monitor control unit is pressed, the
confirmation screen is displayed.
When Panel Calibration is completed
successfully, the monitor changes to the
sleep mode.
Notes
Perform Panel Calibration in the
range of the recommended
environmental temperature (20 °C
to 30 °C (68 °F to 86 °F)).
The monitor screen remains black
for 10 to 30 minutes once
performing is started. A faint
horizontal line may be displayed
depending on the status.
The fan activates during Panel
Calibration.
Submenu
Setting
If the power turns off/on during
Panel Calibration, the process is not
completed successfully. Therefore,
you need to perform Panel
Calibration the next time you turn
on the power.
When Panel Calibration is not
completed successfully, the
[Recommend Re-calibration]
message is displayed. Perform Panel
Calibration again. If the message is
displayed after performing Panel
Calibration a few times, it may be
due to a failure. Contact an
authorized Sony dealer.
It is recommended to perform Panel
Calibration once a week since it is
effective to improve the uniformity
of the screen.
When the CALIBR. indicator lights
in yellow, make sure to perform
Panel Calibration. At this time, the
[Recommend Calibration] message
is displayed.
Use this unit without performing
Panel Calibration. It may not
improve the uniformity of the screen
even if Panel Calibration is
performed.
[Calibration During
Set this to perform Panel Calibration
Sleep]
automatically while in the sleep mode.
"Sleep mode" refers to the status when
the MONITOR
monitor control unit is pressed.
Approximately 5 minutes after
changing to the sleep mode, Panel
Calibration is performed automatically.
At this time, the CALIBR. indicator
blinks in yellow.
When Panel Calibration is completed, it
goes back to sleep mode and the
CALIBR. indicator turns off.
[User Reset]
Returns to the factory default setting
except for the following:
Color temperature for [User1]
Color temperature for [User2]
Color temperature for [User3]
Color temperature for [User4]
Color temperature for [User5]
User Preset for [User Preset1]
Network setting of the monitor
Password setting
[Cancel]: Cancels reset.
[Confirm]: Resets the unit.
switch of the Sony
27
Adjustment Using the Menus
Advertisement
Table of Contents
