Table of Contents
Advertisement
Notes
The signal equivalent to HDMI/SDI 4K cannot be
displayed with Quad View.
Only one Input Setting per input terminal can be
displayed simultaneously.
Example: If [Input Setting1] and [Input Setting2] is set
to the same SDI1 input connector 1, they cannot be
displayed at same time. To compare the same image,
input the image of input connector 1 to the other
connector and set [Input Setting2] to the input
connector.
When a combination which cannot be displayed
simultaneously is set, the screen which can be
displayed is displayed in order from Screen A.
The screen which cannot be displayed turns black and
a message is displayed.
The drive frequency of the panel changes to the same
as Screen A.
The combination of SDI 1 and SDI2 cannot be
displayed with Quad View.
[Native Scan] is set to [Off].
The XYZ format signal is not supported.
Set the same [RGB/YCC Range] settings for the all
screens.
Sets the same frame rate of the signal which is input to
each screen for all screens.
Set [Gamut Marker] and [Mono] to [Off].
The following settings are available with a combination
of Input Setting and User Preset.
38
Adjustment Using the Menus
[Serial Remote] menu
Submenu
Setting
[Monitor]
Sets the monitor setting.
[Network Setting]
[Monitor ID]: Sets the ID of the
[Group ID]: Sets the group ID of the
[IP Address]: Sets the IP address.
[Subnet Mask]: Sets the subnet mask.
[Default Gateway]: Sets the default
[Address]: Sets the default gateway.
[Cancel]: Selects to cancel the setting.
[Confirm]: Selects to save the setting.
[Connection]
Sets the connection of the monitor and
the controller.
[Peer to Peer]: for one to one
[LAN]: for connection via a network
[Controller]
Sets the controller setting.
[Network Setting]
[IP Address]: Sets the IP address.
[Subnet Mask]: Sets the subnet mask.
[Default Gateway]: Sets the default
[Address]: Sets the default gateway.
[Cancel]: Selects to cancel the setting.
[Confirm]: Selects to save the setting.
[Function/
Set functions to be assigned to the F1 to
Numeric Button
F16 buttons and 1 to 9 buttons on the
Setting]
controller.
For the functions which are assigned to
the F1 to F16 buttons of the controller,
see page 15.
For the functions which are assigned to
the 1 to 9 buttons, see "About functions
assigned to the ASSIGN 1/2 buttons"
(page 33).
However, you cannot assign the
[In.Select/In.Setting] function.
Note
[Controller] menu is available when the menu is
displayed via BKM-16R. (Only when BKM-16R is
connected with the Peer to Peer connection or Single
connection.)
monitor.
monitor.
([255.255.255.000])
gateway [On] or [Off].
connection
([255.255.255.000])
gateway [On] or [Off].
Advertisement
Table of Contents
