Alarm Out; Alarm Server; Network Configuration; Port - TBK vision BUL7436EIR User Manual

TBK Vision Plus Network Camera User Manual
1. Select the sensor.
2. The following setup steps are similar to Motion Detection Schedule's. Please refer to
Motion Detection Schedule chapter for more details.

4.4.6 Alarm Out

1. Go to "Alarm configuration" "Alarm output" as shown below:
2. Select alarm holding time and alarm name at the "Alarm out" and "Alarm holding time"
pull down list box respectively.
3. Press the "Save" button to save the settings.

4.4.7 Alarm Server

Go to "Alarm configuration" "Alarm Server" interface as shown below.

You may input the alarm server address and port. When the alarm happens, the camera will
automatically transfer the alarm event to the alarm server. If the alarm server is not used, there
is no need for you to configure here.

4.5 Network Configuration

Network configuration includes nine submenus: Port, IP Address, Server Configuration, IP
Notify, DDNS Config, RTSP, UPNP, Mail configuration and FTP.

4.5.1 Port

1. Go to"Network config""Port" to see the interface as shown below.
21