SatExpander SatX Installation And Operation Manual page 67

SatX/SE300—Front Panel Operation
2. Possible values:
Disable: Channel is disabled, no data is transmitted.
o
Enable: Channel is enabled, data is transmitted.
o
3. Click OK to accept the value.
4.2.6.1.27 AUPC-Max-Attenuation
The AUPC algorithm can be configured to subtract minimal allowed gain from the transmission power.
1. Enter the value using the numeric keypad.
2. Possible values: 0-4dB.
3. Click OK to accept the value.
4.2.6.1.28 AUPC-Operation-Mode
The AUPC algorithm can be configured to subtract minimal allowed gain from the transmission power.
1. Enter the value using the numeric keypad.
2. Possible values:
CeC PWR – AUPC mode is based on Duet Echo reception
o
Local SNR – AUPC mode is based on local SNR variations
o
Local SNR mode is only applicable when Remote modem TX power is controlled reliably.
3. Click OK to accept the value.
4.2.6.1.29 Target-SNR
The AUPC algorithm can be configured to subtract minimal allowed gain from the transmission power.
1. Enter the value using the numeric keypad.
2. Possible values: 0-50dB.
3. Click OK to accept the value.
4.2.6.1.30 Tx Mute after Rx loss
Selects muting modem transmission if modem is not synchronized on a received carrier, to support
regulatory requirements.
This feature is intended for use on mobile modems which are getting out of the satellite
beam coverage.
1. Navigate through the list using the ▲ ▼arrow keys.
2. Possible values:
Enable: Tx mute Enabled, modem will mute transmission when Rx carrier is lost.
o
Disable: Tx mute is Disable.
o
3. Select an item by clicking the OK key.
56
Proprietary and Confidential