SatExpander SatX Installation And Operation Manual page 42

SatX/SE300—Front Panel Operation
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
No - Pattern is not inverted.
o
Yes – Pattern is inverted
o
4. Click OK to select an item.
4.2.2.3 GIGE
Configuration of the GigE port is performed on this submenu.
4.2.2.3.1 RJ-45
4.2.2.3.1.1 Auto-Negotiation
Sets the speed selection protocol of the GigE port.
1. Click OK to change.
2. Browse using the ▲ ▼arrow keys.
3. Possible values:
Enabled – communication parameters are negotiated automatically.
o
Disabled – User needs to set the speed and duplex parameters.
o
4. Click OK to select an item.
4.2.2.3.1.1.1 Speed
Sets the speed selection protocol of the GigE port.
1. Click OK to change.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
10 – Sets speed at 10Mbps.
o
100 – Sets speed at 100Mbps.
o
4. Click OK to select an item.
According to 802.3, 1Gbps can only be auto negotiated.
4.2.2.3.1.1.2 Duplex
Sets the speed selection protocol of the GigE port.
1. Click OK to change.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
Full – Full duplex is enabled.
o
Half – Half Duplex is enabled
o
4. Click OK to select an item.
4.2.2.3.1.1.3 Flow-Control
Sets the physical port type of the GigE port.
1. Click OK to change.
2. Browse using the ▲ ▼arrow keys.
31
Proprietary and Confidential