Table of Contents
Advertisement
SatX/SE300—Front Panel Operation
EC Lost Lock
E3 Connectivity
E3 LOS
E3 AIS
E3 RDI
E3 PHY Link
IPCard Reset
AUPC Power Limit
OU About To Expire:
OU Expired:
SFP Presence
4.2.4.1.4.1
Mask
Enabled items in this submenu will not be displayed on the respective logs under Monitor > Common >
Alarms.
1. In order to change any value, click OK.
Navigate through the list using ◄ ► arrow keys.
2.
3. Select a value by clicking OK.
4. To change a value browsing through the list using the ▲ ▼arrow keys. Possible values are Disable
or Enable.
5. Click OK to save a selection.
4.2.4.1.4.2
Relay Mask
Enabled items are not displayed and do not produce an external signal via the Alarm connector.
4.2.4.2
10MHz Clock
This submenu is used to configure various aspects relating to the 10MHz clock.
1. Click OK to change a value.
2. Use the ◄ ► arrow keys to select an item to configure.
3. Click OK to continue.
4.2.4.2.1 Source
Sets the source of the 10MHz clock needed for the system to operate.
1. Click OK to make a change.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
Internal – Using the internal 10MHz clock.
o
External – (Using the 10MHz REF IN connector on the back panel as input).
o
4. To select a value click OK.
4.2.4.2.2 Data Clock
Sets the internal source of the 10MHz clock.
1. Click OK to make a change.
42
Proprietary and Confidential
Advertisement
Table of Contents
