Table of Contents
Advertisement
SatX/SE300—Front Panel Operation
4.2.6.1.18 Power-up TX State
Sets output power state after reboot.
1. Navigate through the list using the ▲ ▼arrow keys.
2. Possible values:
Enable: modulator will boot up with TX State field in Enable mode, thus with the carrier
o
transmitting. When working in OTA mode, it is highly recommended to set this field to enable
so, if the remote side suffers a power failure, it will be possible to reconnect.
Disable: modulator will boot up with TX State field in Disable mode, thus without carrier
o
transmission.
3. Select an item by clicking the OK key.
4.2.6.1.19 SATEX-NLC-Mode
NLC (Non Linear Constellation) mode uses optimized constellations when working in SATEX ™mode
with a non-linear transponder (saturated transponder), to improve system performance.
1. Press OK and use the ▲ ▼ arrow keys to navigate through the list.
1. Possible values:
o Off: NLC is off, to be used on linear transponder
o On: NLC is on, to be used on non-linear transponder
2. Press OK to save this configuration.
4.2.6.1.20 ACM Mode
Sets activation of the ACM server on the modem. This is most often used for data links, in cases in which
additional fields will be available for ACM configuration. For further details please refer to Chapter 6.
1. Navigate through the list using the ▲ ▼arrow keys.
2. Possible values:
Disable: ACM messages are ignored by modulator.
o
Enable-CH1: ACM messages are monitored by modulator regarding reception quality of
o
channel 1 only.
Enable-CH2: ACM messages are monitored by modulator regarding reception quality of
o
channel 2 only.
Enable-CH1-CH2: ACM messages are monitored by modulator regarding reception quality of
o
both channel 1 and channel 2.
3. Select an item by clicking the OK key.
4.2.6.1.21 AUPC Mode
Selects activation of the AUPC mode on the modem. For further details please refer to Chapter 6.
The AUPC will start operating only if Duet EC and TX mode are enabled and TX Sine Wave
is disabled.
1. Navigate through the list using the ▲ ▼arrow keys.
2. Possible values:
Enable: AUPC is Enabled
o
Disable: AUPC is Disabled
o
54
Proprietary and Confidential
Advertisement
Table of Contents
