SatExpander SatX Installation And Operation Manual page 56

SatX/SE300—Front Panel Operation
Disable – Modem is stand alone.
o
Basic – Modem is connected to a DEV redundancy switch.
o
Advanced – Modem is connected to R-Switch redundancy switch.
o
4. Select a value by clicking OK.
4.2.4.5.2 Basic Redundancy Method
4.2.4.5.2.1 Redundancy Role
Sets the role in the redundancy setup.
1. Click OK to change the value.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
Disable – Modem is stand alone.
o
Main – Modem is designated as primary main modem.
o
Backup – Modem is designated as secondary backup modem.
o
4. Select a value by clicking OK.
4.2.4.5.2.2 Redundancy Mode
Sets the redundancy mode.
1. Click OK to change the value.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
Auto – Switch can be done from Main to Backup and vice versa in case of alarm on active
o
modem.
Latch – Switch will be done only from Main to Backup
o
4. Select a value by clicking OK.
4.2.4.5.2.3 Revert Mode
Sets the redundancy revert mode.
1. Click OK to change the value.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
Disable – After modem switch, reverting to original modem is done by the system
o
administrator after clearing the alarm.
Enable – After modem switch, reverting to original modem is done automatically after
o
clearing the alarm.
4. Select a value by clicking OK.
4.2.4.5.2.4 Redundancy Switch IP
Sets the IP address for the relay switch. Setting the IP address enables IP communication between the
modem and the switch to update the redundancy state of the modem.
1. Click OK to change the value.
2. Navigate through the list using the ◄ ► arrow keys.
3. Modify the string as necessary.
4. Click OK.
45
Proprietary and Confidential