Table of Contents
Advertisement
SatX/SE300—Introduction
Cautions
Caution statements draw attention to anything that could damage equipment or cause the loss of data.
The following are caution statements used in this manual.
To ensure compliance with the electromagnetic regulation all cables must be assembled
professionally ensuring that the outer shield of the coaxial cables is properly attached to the
connectors. The unit is closed and grounded properly via the grounding screw.
Make sure air flow is available on the sides of the SATX/SE300, with at least 1.5 cm free
space on each side.
Before connecting this device to a power line, make sure that the voltage of the power
source matches the requirements of the instrument. The unit must be connected to an earthed
(grounded) outlet to comply with international safety standards.
Disposal of Electronic and Electrical Waste
Pursuant to the WEEE EU Directive electronic and electrical waste must not be disposed of with unsorted waste.
Before initial power up of the SATX/SE300, disconnect the transmit output from the
operating ground station equipment. This is especially pertinent if the current modem configuration
settings are unknown, where incorrect setting could disrupt existing communications traffic. New units
from the factory are normally shipped in a default configuration which includes setting the transmit
carrier off.
Warnings
Warning statements draw attention to anything that could do physical harm to the user. The following
are warning statements used in this manual.
To avoid the possibility of electrical shock, do not attempt to service the device
unless you are qualified to do so.
To avoid the possibility of electrical shock, make sure that the SATX/SE300 is
connected to an earth connection (grounding) via the grounding screw, prior to connecting the unit to a
power source.
1
Proprietary and Confidential
Advertisement
Table of Contents
