SatExpander SatX Installation And Operation Manual page 41

SatX/SE300—Front Panel Operation
1. Click OK to change.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values: 0 to 9
4. Click OK to select an item.
4.2.2.2.2 RX-ASI-A
4.2.2.2.2.1 Source
Sets the physical source for received ASI data.
1. Click OK to change.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
Disable – No Data Source.
o
Channel 1– Channel 1 data via the ASI-OUT-A connector on the rear panel.
o
Channel 2 – Channel 1 data via the ASI-OUT-A connector on the rear panel. (Only valid if dual
o
channel mode is enabled).
4. Click OK to select an item.
4.2.2.2.2.2 Data Invert
Sets the polarity of received ASI data via the ASI-A-OUT connector on the rear panel. Allows the user to
invert the data. Mainly used for compatibility to different IRDs.
1. Click OK to change.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
No - Pattern is not inverted.
o
Yes – Pattern is inverted
o
4. Click OK to select an item.
4.2.2.2.3 RX-ASI-B
4.2.2.2.3.1 Source
Sets the physical source for received ASI data.
1. Click OK to change.
2. Navigate through the list using the ▲ ▼arrow keys.
3. Possible values:
Disable – No Data Source.
o
Channel 1– Channel 1 data via the ASI-OUT-B connector on the rear panel.
o
Channel 2- Channel 1 data via the ASI-OUT-B connector on the rear panel. (Only valid of dual
o
channel mode is enabled).
4. Click OK to select an item.
4.2.2.2.3.2 Data Invert
Sets the polarity of received ASI data via ASI-B-OUT connector on the rear panel. Allows the user to
invert the data. Mainly used for compatibility to different IRDs.
1. Click OK to change.
31
Proprietary and Confidential