SatExpander SatX Installation And Operation Manual page 62

SatX/SE300—Front Panel Operation
4.2.6.1.4 BUC Feeder Output
Determines BUC feeder behavior. All signals are available once the TX state is enabled.
This field is active only with BUC feeder hardware option.
1. Navigate through the list using the ▲ ▼arrow keys.
2. Possible values:
RF Only: Only RF carrier is present on L-Band connector.
o
RF & DC: RF carrier and DC voltage are present on L-Band connector.
o
RF & 10MHz: RF carrier and 10MHz clock are present on L-Band connector.
o
RF, 10MHz & DC: RF carrier and 10MHz clock and DC voltage are present on L-Band
o
connector.
3. Click OK to accept the value.
4.2.6.1.5 RF-Freq
Sets IF or L-Band frequency selection of the demodulator.
1. Enter the frequency using the numeric keypad.
2. Possible values:
IF: 50-90MHz and 100-180MHz
o
L-Band: 950 – 2150MHz
o
3. Click OK to accept the value.
If the LNB-LO-Freq is used, the RF Frequency shown will be the sum of the two values.
4.2.6.1.6 Sine Wave
Sets modulator's output for continues wave.
1. Navigate through the list using the ▲ ▼arrow keys.
2. Possible values:
Off: modulation is on.
o
On: modulation is off, output signal is a CW (continuous wave), at the same given power as
o
the modulated signal would be.
3. Click OK to accept the value.
4.2.6.1.7 Dual-Channel-Mode
Sets single or dual channel mode or operation per carrier option. The dual channels mode support the
following options:
Video stream from ASI-A + video stream from ASI-B
o
IP data from Gig-E + video stream from ASI.
o
IP data from Gig-E + internal PRBS generator.
o
Internal PRBS generator + video stream from ASI
o
1. Navigate through the list using the ▲ ▼arrow keys.
2. Possible values:
Single: Single channel is used
o
51
Proprietary and Confidential