Removing And Replacing The Case Group Parts - Keysight N9912A Service Manual

Repair and Replacement Procedures

Removing and Replacing the Case Group Parts

Removing and Replacing the Case Group Parts
Tools Required
• T-8 TORX driver (set to 6 in-lb)
• T-10 TORX driver (set to 9 in-lb)
• Isopropyl alcohol (Use only in a well ventilated area.)
• Repair and Re-assembly
WARNING Before beginning any repair, disconnect the power cord.
Replacing the Kickstand, Hinge Cover, and Hinge
1. Remove, and discard, the four screws (item 1) from the kickstand hinge cover. New screws are provided
in the Repair and Re-assembly
Figure 7-2 Replacing the Kickstand and Hinge Cover
7-6
Kit. Refer to "Miscellaneous Parts" on page
Kit.
RF Analyzer
6-14.
Service Guide N9912-90003
N9912A