Panasonic AJ-HD2000 Operating Instructions Manual page 77

TC/CHR menu
∑ Changing the superimposing position
∑ Time code displays and VTR's operating modes
Display the time codes and VTR's operating modes as required.
Time code displays
CTL1: Control signal 1
CTL2: Control signal 2
LTCR: LTC time code readout value
LUBR: LTC user bit readout value
VTCR: VITC time code readout value
VUBR: VITC user bit readout value
≥The colon (":") between the seconds and frames denotes the readout mode of the time code
reader.
Hours Minutes Seconds Frames
;
This indicates that the time code is the original time code which was recorded on the tape.
If the time code displayed is not accompanied by this cassette mark, it means that the time
code is the post-conversion time code. (This display will go off when setting the CTL or UB.)
(1) Move the position using the cursor keys.
≥When a cursor key is held down, the cursor will move more
quickly.
≥When the center cursor key is pressed, the superimposing re-
turns to its initial position.
; ; ;
<
Blinking display: Time code cannot be read out.
[ ]: First field
[. ]: Second field
[: ]: Time code can be read out or TCG value is displayed.
[ ]: Time code cannot be read out.
[. ]: DF mode ON
[: ]: DF mode OFF
– 77 –
Center cursor key
Cursor keys
TCG: Value generated by time code generator
LUBG: Value of LTC user bit generated
VUBG: Value of VITC user bit generated
EXTC: External time code value
EXUB: External user bit value