Panasonic AJ-HD2000 Operating Instructions Manual page 10

HOME menu displays
∑ Setting mode display area
∑ Remaining tape time
∑ User file display
∑ Time code displays
∑ Checking the value generated by generator
INPUT CHECK
The displays appearing in this area indicate the modes which
have been set.
CUT: Appears when the audio cut editing mode is set.
XFADE: Appears when the audio cross-fade editing mode
is set.
VFADE: Appears when the audio V fade editing mode is
set.
INTRP: Appears when the time code interpolation mode (in
which the time code cannot be read out accurate-
ly) is established.
DF: Appears when the drop frame mode is set.
F1/F2: Indicates the field numbers for VITC.
EMPHASIS: Appears when pre-emphasis is applied to the
audio signals.
TRACK VAR: Appears when an adjustment has been made with
the tracking deviated from the fixed position.
TRACK OPT: Appears when an optimizing adjustment has been
made for the tracking.
This indicates the remaining tape time as the tape travels.
This indicates the number of file which is called when the power is
switched on or the currently called user file. If there is a discrep-
ancy between the contents of the user file displays and even one
current setting, "¢" will appear in front of the file number.
These indicate the time code values.
CTL1: Normal control signal
CTL2: Control signal (which cannot be reset)
LTCR: LTC readout
LUBR: LTC user bit readout
VTCR: VITC readout
VUBR: VITC user bit readout
TCG: Value generated by generator
LUBG: Value of LTC user bit generated
VUBG: Value of VITC user bit generated
E-TC: External time code
E-UB: External user bit
Press the INPUT CHECK key. While the key is held down, the
value generated by the generator is displayed.
TCG
00 : 41 : 07 : 04
– 10 –