Panasonic AJ-HD2000 Operating Instructions Manual page 124

INTERFACE SET UP menu
Key Key designation
F7 PREREAD° 1
For setting pre-read from
the remote commands.
F8 EXIT
F9 UB PRESET
For setting the UB preset
from remote.
F10 VAR LIMT° 2
F11 V. LEV. CNT
F12–F13 — —
1 This item appears only when an SD format (525/59i or 625/50i) is used as the system format.
°
2
ONoteN
°
2 Set this item to OFF for slow editing with the unit connected to an editing controller (such as the BVE-9100).
°
Phase synchronization may not be possible with slow editing near the
The setting can be changed by pressing the F7 key while holding
down the F key.
VIDEO: Video pre-read can be set.
AUDIO: Audio pre-read can be set.
V&A: Both video and audio pre-read can be set.
Returns the VTR to the SET UP menu screen.
Selects the setting destination for the TCG UB preset command
supplied from the external source (RS-422/232C).
L&V: Sets the destination for LTC UB and VITC UB.
LTC: Sets the destination for LTC UB only.
VITC: Sets the destination for VITC UB only.
Selects the limit speed for the VAR command supplied from the
external source (RS-422/232C).
This item can be set by pressing the F10 key and F key together.
ON: The tape speed is limited to the range from j1x to i2x
normal speed.
OFF: The tape speed is limited to the range from j1.5x to
i2.5x normal speed. (At speed above 2x or so or below
j1x, pictures are searched without AT ON TRACK.)
Selects whether to vary the VTR HD/SD output in response to an
external video component adjustment command (RS-422, V/A
controller).
NORMAL: Identifies HD/SD commands and varies the level of
each.
HD: Varies HD output level forcibly.
SD: Varies SD output level forcibly.
BOTH: Varies This is varied in tandem with the HD
output/SD output level.
– 124 –
Description
1t or 2t speed.
j i