Panasonic AJ-HD2000 Operating Instructions Manual page 183

DIAG error messages
Message
WRONG OPTIMIZED
TRACKING VALUE
SERVO UNLOCKED
BEFORE IN POINT
NO EXTERNAL HD REF
NO EXTERNAL SD REF
NO COLOR BURST IN SD
REF
NO STANDARD
SCH-RANGE IN REF
NO HD SDI INPUT
CRC ERROR IN HD SDI
INPUT
NO EMBEDDED AUDIO
(CH1/2/3/4) INPUT
NO EMBEDDED AUDIO
(CH5/6/7/8) INPUT
AUDIO (CH1/2/3/4) DATA
ERROR IN HD SDI INPUT
AUDIO (CH5/6/7/8) DATA
ERROR IN HD SDI INPUT
NO EMBEDDED LTC
LTC ERROR IN HD SDI
INPUT
NO EMBEDDED VITC
VITC ERROR IN HD SDI
INPUT
NO SD SDI INPUT
NO EMBEDDED AUDIO
(CH1/2/3/4) INPUT
NO EMBEDDED AUDIO
(CH5/6/7/8) INPUT
UNMATCH AUDIO
RECORDED FORMAT
CHECK CASSETTE C BIT
UNMATCH AUDIO
RECORDED FORMAT
CHECK SYSTEM FORMAT
Error description
The tracking optimizing operation resulted in a
drop in the maximum envelope level by over
25%. Check the tape playback mode.
The servo was disengaged (unlocked) before an
edit IN point.
The REF signal is not supplied to the HD REF
input connector.
The REF signal is not supplied to the SD REF
input connector.
There is no burst signal in the SD REF signal.
A problem has occurred in SCH of the SD REF
signal.
There is no HD SDI input.
A CRC error has been detected from the HD
SDI input signal.
Audio signals are not detected in the HD SDI
input signal.
Audio signals are not detected in the HD SDI
input signal.
A transmission error was detected in the audio
signals of the HD SDI input signal.
A transmission error was detected in the audio
signals of the HD SDI input signal.
The LTC signal is not detected in the HD SDI
input signal.
A transmission error was detected in the LTC
signal of the HD SDI input signal.
The VITC signal is not detected in the HD SDI
input signal.
A transmission error was detected in the VITC
signal of the HD SDI input signal.
There is no SD SDI input.
Audio signals are not detected in the SD SDI
input signal.
Audio signals are not detected in the SD SDI
input signal.
Check the C hole (for identifying the 4-channel/
8-channel format) on the cassette. The C hole
information and 4- or 8-channel format
information recorded on the tape do not match.
(When PB.AUTOlON)
Check the VTR system format. The 4- or
8-channel format information recorded on the
tape and the 4 or 8 channels set for the VTR
system do not match. (When PB.AUTOlOFF)
– 183 –
On-screen display
OPT ERROR
OPT ERROR
HD REF ERROR
SD REF ERROR
SD REF ERROR
SD REF ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
HD SDI ERROR
SD SDI ERROR
SD SDI ERROR
SD SDI ERROR
FRMT UNMATCH
FRMT UNMATCH