Panasonic AJ-HD2000 Operating Instructions Manual page 119

INSERT/ASSEMBLE AUTO EDIT SET UP menu
Key Key designation
F8 EXIT
F9 DLY STRT
Delay start.
F10 TRACKING
For adjusting the tracking.
F11 CAP LOCK
For setting the capstan
servo lock.
F12 FD TIME° 2
For setting the audio fade
time.
F13 MODE° 2
For selecting audio fade
editing.
1 This range differs depending on the format used.
°
2 Only CUT can be selected when TAPE has been selected as the EDIT REC STATE setting. However, FADE can be
°
selected by pressing this key and F key together, in which case the EDIT REC STATE setting is switched to EE1.
Returns the VTR to the AUTO EDIT menu screen.
Sets the timing after the playback command was issued until the
actual operation in 1-frame increments. (This is used to facilitate
the synchronization with another VTR which has a different servo
reference.)
The timing can be set from j30 frames to i30 frames°
1-frame increments. (Initial setting is 0 frame.) (With a "j" value,
the operation is performed earlier, and the preroll time is
compensated for in the LOCAL mode. With a "i" value, the
operation is performed later, and it takes effect both in the
REMOTE and LOCAL modes.)
At normal times, tracking adjustment is not necessary. Adjustment
is made if tracking disparities have occurred during editing.
VAR: The tracking can be adjusted manually.
Refer to "Manually adjusting the tracking" (on page 106).
FIX: The tracking is fixed.
OPT. ONCE: At the initial editing after the cassette has been
inserted, the tracking is optimized while the tape is
playing back up to the IN point. The tracking is not
subsequently optimized. Tracking can be optimized
again. Refer to "Automatically adjusting the
tracking" (on page 105). When the PLAY button
and STAND BY button are pressed together during
EDIT/PLAY, the tracking is optimized again, and it
is optimized with each EDIT/PLAY operation.
OPT. AUTO: The tracking is optimized while the tape is playing
back up to the IN point with each editing operation,
and it is retained even if the VTR is transferred to
another menu. Refer to "Automatically adjusting the
tracking" (on page 105).
For selecting the capstan servo lock mode during playback.
4F AUTO (8F AUTO: 1080/23p, 1080/24p, 1080/25p, 1080/50i, 576/50i):
Assumes the color frame auto lock mode. If discontinuity is
produced in the color frame during playback, the unit locks again
to a new color frame.
4F FORCE (8F FORCE: 1080/23p, 1080/24p, 1080/25p, 1080/50i, 576/50i):
Assumes the color frame forced lock mode. If there is any
discontinuity in the color frame during playback, the unit
preserves the field sequence at initial lock.
2F: Assumes frame lock mode.
≥The capstan servo lock mode can be set in HOME SET UP menu.
If the two settings differ, priority is given to the final mode setting.
Valid when the F13 key is set to X FADE or V FADE.
The times that can be set are as follows: 5, 10, 15, 20, 25, 50,
100 ms. (Initial setting is 5 ms.)
For the setting procedure, refer to "Setting the audio fade time"
(on page 107).
Audio editing can be accomplished while cross-fade editing prior
playback audio and input audio or V-fade editing.
X FADE: Performs audio cross-fade editing.
CUT: Performs cut (normal) editing.
V FADE: Performs audio V-fade editing.
– 119 –
Description
1 in