Panasonic AJ-HD2000 Operating Instructions Manual page 41

VIDEO OUT SET UP STATE menu
∑ Selecting the TAPE/EE output signals
The video, audio and cue signals which are output during the VTR's operation are switched on
this menu to TAPE or EE signals.
(1) Press the center cursor key to display the cursor.
(2) Move the cursor to the desired position using the cursor keys.
°The cursor will not move to places which cannot be set.
(3) Press the center cursor key to select TAPE or EE.
Refer to the following table for the types of setting options.
CH
VIDEO
D.AUDIO
CUE
≥When a setting is to be established during head selection using the TEST menu or during edit-
ing, the setting applying to the operation concerned takes precedence over the setting select-
ed using the VIDEO OUT SET UP STATE menu.
≥When TAPE/EE has been set by F1 (OUTPUT) on the HOME menu, the HOME menu setting
takes precedence.
Center cursor key
Cursor key
Mode EJECT STBY
OFF
FREEZE FREEZE
BLACK BLACK
GRAY GRAY
FREE FREE
NOISE NOISE
EE1 EE1
EE2 EE2
MUTE MUTE
EE1 EE1
EE2 EE2
TAPE TAPE
EE EE
– 41 –
TENSION STBY REC
RELEASE ON
FREEZE TAPE TAPE
BLACK EE1 EE1
GRAY EE2 EE2
FREE
NOISE
EE1
EE2
MUTE MUTE TAPE
EE1 EE1 EE1
EE2 EE2 EE2
TAPE TAPE EE
EE EE
(Underline denotes the factory setting mode.)
EDIT JOG/ SHTL
REC VAR
TAPE TAPE TAPE
EE1
TAPE TAPE TAPE
EE1 MUTE MUTE
EE TAPE TAPE