Panasonic AJ-HD2000 Operating Instructions Manual page 114

INSERT/ASSEMBLE AUTO EDIT menu
∑ Variable memory editing
By operating the search dial on a VTR connected to the unit's RS-422A REMOTE OUT connector or REMOTE
IN/OUT connector, the playback speed and direction can be stored in that VTR's memory, and the memory
data can be reproduced during automatic editing and stored in this unit (recorder).
1. Set the F3 (W/PLYR) key to ON.
∫ To operate the VTR connected to the REMOTE OUT connector by remote control, set
F5 (PLYR SEL) on the ASSEMBLE/INSERT AUTO EDIT menu to PLAY-1.
∫ To operate the VTR connected to the REMOTE IN/OUT connector by remote control, set
F5 (PLYR SEL) on the ASSEMBLE/INSERT AUTO EDIT menu to PLAY-2.
2. Set the F4 (VAR MEMO) key to ON.
3. Enter the recorder's video IN and OUT points as well as the player's IN point.
4. Select the player using the F6 (R/P SEL) key, and set the initial speed using the search dial.
The initial speed is now shown on the search indicator.
5. Press the PREVIEW/REVIEW button.
The tape travels to the preroll point, and playback starts at the initial speed.
6. When the edit IN point is passed, the EXECUTE button lamp starts blinking.
7. Use the recorder's search dial to store the speed up to the recorder's OUT point in the me-
mory.
The data can be stored in the memory up to the recorder's OUT point while the EXECUTE
button lamp is blinking. When the memory becomes full, the EXECUTE button lamp comes
on, and no more data can be stored in the memory.
8. To preview data stored in the memory, press the PREVIEW/REVIEW button.
The data stored in the memory is then reproduced.
Phase synchronization is not performed. To adjust the edit timing, use the F9 (DLY STRT)
key on the INSERT/ASSEMBLE AUTO EDIT SET UP menu.
9. To change the data stored in the memory during preview, operate the search dial. The
EXECUTE button lamp blinks, and the new data is stored.
10. Press the STOP button to change the initial speed which was stored in the memory.
Set the F6 (R/P SEL) key to PLAYER, and set the initial speed using the search dial while
pressing the STOP button. If the initial speed is changed, the data stored in the memory will
be cleared so repeat the operation from step 5.
11. To proceed with variable memory automatic editing, press the REC/EDIT button. The play-
er's tape is played back in accordance with the data stored in the memory and entered in this
unit (recorder).
12. To review, press the REC/EDIT button and, upon completion of the editing, press the PRE-
VIEW/REVIEW button.
≥The data stored in the memory is cleared when the F10 (VAR MEMO) key is set from OFF
to ON.
≥The data stored in the memory is also cleared when the power switch is set to OFF.
W/PLYR
ON
VAR MEMO
ON
– 114 –