Panasonic AJ-HD1400E Operating Instructions Manual page 52

Setup menus
(continued)
AUDIO (continued)
No./Item Description of setting
750 For selecting the channel for the signal output to the
analog audio output terminal CH1/CH2.
ANA CH1/2
0000 CH1/2
SEL
0001 CH3/4
0002 CH5/6
0003 CH7/8
1 For selecting the audio output level during DV format
759*
playback.
DV PB ATT
0000 OFF :
The audio output level is not attenuated.
0001 ON :
The audio output level is attenuated.
1 For selecting whether to mute the sound at the joins
760*
in the recording during DV or DVCAM format
REC PT
playback.
MUTE
0000 OFF :
The sound is not muted.
0001 ON :
The sound is muted.
762 For setting whether the tape is to be played back
without passing the signals through the rate converter
AUD RATE
(without activating the digital filter) in the digital audio
CON
output unit.
0000 OFF :
The tape is played back without passing the signals
through the rate converter.
0001 ON :
The signals are passed through the rate converter,
and the tape is played back.
<Note>
ON/OFF control is exercised for channels 1 through 8
at the same time. Separate settings cannot be
performed on a channel by channel basis.
765 For setting whether to output the analog CUE signal
to CH1/2 for the analog audio output.
CUE OUT
0000 OFF :
SEL
The analog CUE signal is not output.
The PCM audio signal is output when the speed
range is less than j1.0k to +1.0k; while the no
audio signal is output at any other speed.
0001 ON :
The analog CUE signal is output.
The PCM audio signal is output when the speed
range is less than j1.0k to +1.0k; while the
analog CUE signal is output at any other speed.
1 For setting the analog audio input impedance.
781*
0000 600 :
IN IMP SEL
600h
0001 HIGH :
High impedance
<Note>
Regardless of this setting, the impedance is set to
3kh. when "–60 dB" is selected as the menu item
No.701 to 702 settings.
52
No./Item Description of setting
782 Set the channels to multiplex SD-SDI output.
0000 CH1-4 :
EMBD CH
0001 CH5-8 :
SEL
<Note>
When tape other than DVCPRO HD (LP) is played,
CH1 to CH4 is always multiplexed.
783 For selecting channels that are adjusted with the
audio volume control on the front panel and displayed
AUDIO CH
on the audio level meter.
SEL
0000 CH1-4 :
Select CH1–CH4.
0001 CH5-8 :
Select CH5–CH8.
784 Select enabled/disabled for MONITOR SELECT
button operation on the front panel.
MONI SEL
0000 OFF :
INH
Operation is enabled.
0001 ON :
Operation is disabled.
0002 ON1 :
Operation is disabled in the FULL display mode
while the operation is enabled only in the FINE
display mode.
*1 Displayed menus may vary depending on the settings in
menu No. 25 SYSTEM FREQ. For details, refer to
"Menus which are displayed" (page 32).
"_____" indicates the factory setting.