Mounting The Device; Mounting The Device On A Din Rail - Siemens RUGGEDCOM RS900GP Installation Manual

Chapter 2
Installing the Device
Section 2.1

Mounting the Device

The RUGGEDCOM RS900GP is designed for maximum mounting and display flexibility. It can be equipped with
connectors that allow it to be installed in a 35 mm (1.4 in) DIN rail or directly on a panel.
NOTE
For detailed dimensions of the device with either DIN rail or panel hardware installed, refer to
Chapter 5, Dimension
The following sections describe the various methods of mounting the device:
• Section 2.1.1, "Mounting the Device on a DIN Rail"
• Section 2.1.2, "Mounting the Device to a Panel"
Section 2.1.1

Mounting the Device on a DIN Rail

For DIN rail installations, the RUGGEDCOM RS900GP can be equipped with a DIN rail bracket that allows the
device to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Secure the DIN rail bracket to the back of the device chassis.
Figure 2: DIN Rail Bracket Assembly
1. DIN Rail Bracket
2. Align the slot in the bracket with the DIN rail.
6
Drawings.
2. Screw
RUGGEDCOM RS900GP
Installation Guide
2
1
Mounting the Device