Table of Contents
Advertisement
Cleaning
Cleaning under the Mower
Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Disengage the PTO, move the motion-control levers to
the N
-
EUTRAL
LOCK
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the T
Disposing of Waste
Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
position, and set the parking brake.
position.
RANSPORT
Storage
Cleaning and Storage
1. Disengage the power takeoff (PTO), set the parking
brake, and turn the ignition key to the O
Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake; refer to
(page
50).
Service the air cleaner; refer to
(page
37).
4. Grease the machine; refer to
5. Change the crankcase oil; refer to
Oil (page
38).
Check the tire pressure; refer to
Maintenance (page
6. Change the hydraulic filter; refer to
Maintenance (page
7. Charge the battery; refer to
Maintenance (page
8. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the PTO engaged and
the engine at high idle for 2 to 5 minutes after washing.
9. Check the condition of the blades; refer to
the Cutting Blades (page
Prepare the machine for storage when you are not
using it for more than 30 days. Prepare the machine
for storage as follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Shut off the engine, allow it to cool, and drain
the fuel tank; refer to
(page
41).
63
position.
FF
Adjusting the Parking Brake
Engine Maintenance
Lubrication (page
Servicing the Engine
Drive System
45).
Hydraulic System
54).
Electrical System
42).
Servicing
60).
Fuel System Maintenance
35).
Advertisement
Table of Contents
