Mower Deck Maintenance; Leveling The Mower - Toro Z Master Professional 7000Series 74264TE Operator's Manual

WARNING
The electrical system does not perform the
proper safety shut off process with a jumper
wire installed.
• Remove the jumper wire from the wire
harness connector and plug the connector
into the seat switch when you complete an
adjustment.
• Never operate the machine with a jumper
installed and the seat switch bypassed.
7. After both of the pump neutrals are set, shut off the
machine.
8. Remove the jumper wire from the wire harness
connector and plug the connector into the seat switch.
9. Install the seat rod and lower the seat into position.
10. Remove the jack stands.
Mower Deck
Maintenance

Leveling the Mower

Setting up the Machine
1. Position mower on a flat surface.
2. Disengage the PTO, move the motion-control levers to
the N -
EUTRAL LOCK
3. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Check tire pressure of all 4 tires. If needed, adjust to
90 kPa (13 psi).
5. Lower the mower to the 76 mm (3 inch) height-of-cut
position.
6. Inspect the 4 chains. The chains need to have tension.
•
If 1 rear chain is loose, lower (loosen) the front
support arm on the same side. Refer to
•
If 1 front chain is loose, raise (tighten) the front
support arm for that chain. Refer to
Leveling the Mower Side-to-Side
1. Position the right blade side-to-side
1. Measure here from the
blade to a hard surface.
2. Measure the right blade at the B location, from a level
surface to the cutting edge of the blade tip
3. Record this measurement. This measurement needs to
be 80 to 83 mm (3-1/8 to 3-1/4 inches).
4. Position the left blade side-to-side
5. Measure the left blade at the C location
from a level surface to the cutting edge of the blade tip.
58
position, and set the parking brake.
(page
(page
(Figure 80).
Figure 80
2. Measure at B and C.
(Figure
(Figure 80).
(Figure
).
).
80).
80),