Table of Contents
Advertisement
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged (1.265
specific gravity). This is especially important to prevent
battery damage when the temperature is below 0°C
(32°F).
1. Make sure that the filler caps are installed in the battery.
Charge the battery for 10 to 15 minutes at 25 to 30
A or 30 minutes at 10 A.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables, refer to
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
Figure 55
1. Positive battery post
2. Negative battery post
(Figure
55).
Installing the Battery (page
3. Red (+) charger lead
4. Black (-) charger lead
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short.
1. Unlatch the engine hood and raise the engine hood to
gain access to fuse holder
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse
43).
1. Ignition—30 A (F1)
2. Radiator fan—50 A (large,
heavy duty fuse)
44
(Figure
56).
(Figure
56).
1
3
4
Figure 56
3. Clutch—10 A (F3)
4. Left side fuel tank
2
G012492
Advertisement
Table of Contents
