Operating The Parking Brake; Starting And Stopping The Engine - Toro Z Master Professional 7000Series 74264TE Operator's Manual

Operating the Parking Brake

Always set the parking brake when you stop the machine or
leave it unattended.
Setting the Parking Brake
1. Move the motion-control levers
N - position.
EUTRAL LOCK
2. Pull up and back on the parking-brake lever to set the
parking brake (Figure
should stay firmly in the E
WARNING
The parking brake may not hold the machine
parked on a slope and could cause personal
injury or property damage.
Do not park the machine on slopes unless the
wheels are chocked or blocked
Releasing the Parking Brake
Push forward and down on the parking-brake lever to
release the parking brake
disengaged and the lever rests against the brake stop.
1. O position
N
2. O position
FF
(Figure 18) out to the
12). The parking-brake lever
position.
NGAGED
(Figure 12). The parking brake is
Figure 12
3. Brake Stop
Starting and Stopping the
Engine
Starting the Engine in Normal Weather
Important: Use starting cycles of no more than 30
seconds per minute to avoid overheating the starter
motor.
Note: Additional starting cycles may be required when
starting the engine for the first time after the fuel system has
been completely without fuel.
21
Figure 13