Changing The Seat Suspension; Unlatching The Seat; Pushing The Machine By Hand - Toro Z Master Professional 7000Series 74264TE Operator's Manual

Changing the Seat Suspension

The seat is adjustable to provide a smooth and comfortable
ride. Move the seat to the position where you are most
comfortable.
To adjust it the seat, turn the seat-suspension knob either
direction to provide the best comfort
1
1. Seat-suspension knob

Unlatching the Seat

1. Move the seat to the most rearward position. This
prevents interference when you raise the seat.
2. Push the seat latch rearward to unlatch the seat.
3. Raise the seat up. This allows access to the machine
under the seat (Figure
1. Seat latch
2. Fuel cap
(Figure 29).
g019768
Figure 29
30).
Figure 30
3. Seat

Pushing the Machine by Hand

Important: Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
Pushing the Machine
1. Disengage the power takeoff (PTO) and turn the
ignition key to the O
the N -
EUTRAL LOCK
and remove the key.
2. Rotate the bypass valves counterclockwise 1 turn. This
allows hydraulic fluid to bypass the pump, enabling the
wheels to turn (Figure
Important: Do not rotate the bypass valves more
than 1 turn. This prevents the valves from coming
out and causing fluid to run out.
3. Disengage the parking brake before pushing the
machine.
Changing to Machine Operation
Rotate the bypass valves clockwise 1 turn to operate machine
(Figure 31).
Note: Do not over tighten the bypass valves.
The machine does not drive unless the bypass valves are
turned in.
1. Side console controls
2. Bypass valve
28
position. Move the levers to
FF
position, apply the parking brake,
31).
Figure 31
3. Hydraulic pumps