Recorder Connection - Panasonic WJ-SX650 Operating Instructions Manual

■ Recorder Connection

The following is a connection example to use recorders.
Note: Use recorders with the following versions.
• WJ-HD300 Series: Ver. 1.61 or later
• WJ-HD300A Series: Ver. 3.10 or later
● Connection to Video Output Connectors of Recorders
To display recorder images on monitors connected to this unit
When the video output connectors of recorders are connected to CAMERA IN connectors of this unit, recorder images can be
displayed on Monitor 1 to 32.
The following is the connection procedure.
1. Assign unit addresses to the recorders. (Refer to p. 67 q.)
Available unit addresses are 1 to 16. The unit address setting must be different from each other.
2. Decide the video input board to supply video input signals from recorder.
Choose a video input board that has more unused connectors (CAMERA IN 17 to 32) than the recorder total number.
Note: Only one video input board can be connected to the video output connector of recorders.
3. Connect the video output connectors (the monitor output 2 connector) of recorders and the CAMERA IN 17 to 32 connec-
tors of the unit.
Recorder's unit address
1
2
3
4
5
6
7
8
Note: To supply video input signals from recorders to video input boards, perform the settings surely in RECORDER of SETUP
MENU (refer to p. 87) or "System" – "Recorder" of WJ-SX650 Series Administrator Console.
30
CAMERA IN channel of
video input board
32
31
30
29
28
27
26
25
Recorder's unit address
9
10
11
12
13
14
15
16
CAMERA IN channel of
video input board
24
23
22
21
20
19
18
17