Panasonic WJ-SX650 Operating Instructions Manual page 32

Notes:
• When changing connections, perform the LCN settings of camera channels supplying video input signals to recorders. The
LCN settings are performed in "System" – "Recorder" – "Logical Camera Number".
• Camera input signals are looped through the unit. Monitor display information (camera title, etc.) are not recorded.
Video input signals are supplied from
recorders to the CAMERA IN 31 and 32.
32 31 30
Unit Address (System): 2
Do not connect VIDEO OUT of the unit to CAMERA IN of recorders if these
camera channels supply video output signals from recorders.
Note: Do not connect the VIDEO OUT ports of the unit to the CAMERA IN connectors of recorders if these camera channels
supply video output signals from recorders.
● Connection between Recorders and Video Input Boards
By connecting recorders to the DATA ports of this unit, recorder control becomes available from system controllers.
Recorder's unit address (System)
1 to 4
5 to 8
9 to 12
13 to 16
Note: You can change data port settings according to the connected devices. Setting changes are performed in "System" –
"DATA Port" of WJ-SX650 Series Administrator Console or DATA PORT (refer to p. 90) of SETUP MENU.
32
EXTENSION 3 IN EXTENSION 2 IN
VIDEO OUT 4 VIDEO OUT 3
32 31 30 29 28 27
16 15 14 13 12 11
25 24 17 16
Recorder
LCN: 17 to 32
DATA port for recorder connection
DATA 3 port of Video Output Board 1
(Factory default: HDR1)
DATA 4 port of Video Output Board 1
(Factory default: HDR2)
DATA 3 port of Video Output Board 2
(Factory default: HDR3)
DATA 4 port of Video Output Board 2
(Factory default: HDR4)
4 3
RS485 (CAMERA)
MODE MODE MODE
VIDEO OUT 2 VIDEO OUT 1
26 25 24 23 22
10 9 8 7 6
CAMERA IN
9 8 1
Recorder
LCN: 1 to 16
Unit Address (System): 1
2 1
RS485 (CAMERA)
MODE IN C-3
ALARM IN IN X-2
21 20 19 18 17
5 4 3 2 1
IN X-1
D-sub/BNC Video Cable WJ-CA68
BNC cable
Video input
board