Monitor Control; Monitor Selection; Monitor Lock - Panasonic WJ-SX650 Operating Instructions Manual

MONITOR CONTROL

The following is the procedure examples for monitor selec-
tion. Refer to p. 36 Lists of Functions and Operations for
other monitor control procedures not described here.

■ Monitor Selection

In the following procedure, you can display camera images
or perform setup procedures on a desired monitor.
1. Enter the desired monitor number by pressing the
numeric buttons. The entered number will appear on
the LCD.
<WV-CU950/650>
2. Press the MON (ESC) button. The specified monitor will
be selected, and the system will become ready for
monitor control.
<WV-CU950/650>
3. Control the selected monitor.

■ Monitor Lock

When you log out of the system or select another monitor,
this function can prevent operators with lower priority from
gaining control of the selected monitor and camera(s).
● WV-CU950/650
1. Press the MON LOCK button. The selected monitor will
be locked.
2. To release the monitor lock, press the MON LOCK but-
ton again.
● WV-CU360C/CJ
1. Press the MON LOCK button while holding down the
SHIFT button.
The selected monitor will be locked.
<WV-CU360C/360CJ>
<WV-CU360C/360CJ>
2. To release the monitor lock, press the MON LOCK but-
ton again.
● Notes:
• Monitor lock is released when you select the monitor
again, or an operator with higher priority selects the
monitor.
• Even after you log out of the system or select another
monitor, the camera image or sequence is continuously
displayed on the selected monitor.
57