Epson Stylus C110 Service Manual page 78

EPSON Stylus C110/C120/D120
Be careful not to damage the PF Scale and the Spur Gear of
the EJ roller when installing the Main Board Unit and the
Panel Unit.
Route the Panel Unit FFC on the Main Board Unit and the
Panel Unit referring to the figure below. Make sure to fold the
FFC as shown.
Align the edge of the FFC
with the edge of the Left
Frame.
When installing the Main Board Unit, be sure to insert the
tabs (x2) of the Main Board Unit into the slots of the Base
Frame (x2).
DISASSEMBLY/ASSEMBLY
Downloaded from www.Manualslib.com
Panel Unit FFC
9 to 10 mm
(from the slot on the
frame to the tape edge)
Double-sided tape position
Figure 4-14. Routing Panel Unit FFC
Tab
Figure 4-15. Installing Main Board Unit
manuals search engine
Slot
A D J U S T M E N T
R E Q U I R E D
Removing Board
When routing the Head FFC on the Left Frame, secure the
Head FFC with an acetate tape on the specified position as
shown in the figure below.
Align here with
Inside of the frame
the cutout of the
Left Frame.
50 mm
Align the edge of the tape with
the corner of Left Frame.
Figure 4-16. Acetate Tape Position
Be cautious of the following points when connecting the cables
to the Main Board.
1. Do not let the cables and FFCs over the USB interface.
2. Route the CR Motor cable and the PF Motor cable through the
gap between their connectors.
.
1
Figure 4-17. Routing cables on the Main Board
After replacing the Main Board Unit, be sure to perform specified
adjustment. See Chapter 5 " ADJUSTMENT" (p.107)
Revision B
Outside of the frame
Wrap the tape around the
frame and the Head FFC.
2
USB Interface
78