EPSON Stylus C110/C120/D120
Occurrence timing
Detailed phenomenon
CR position
• Operation
The drive of the PF Motor is not
transmitted to the LD Roller Shaft.
•
–
TROUBLESHOOTING
Downloaded from
www.Manualslib.com
Table 3-8. Check point for paper out error according to each phenomenon
Defective unit/
part name
ASF Unit
manuals search engine
Check point
1. Check if the Extension Spring 0.143 does not come off in
the Clutch mechanism.
Extension Spring 0.143
2. Check if the positioning hole of the Clutch does not come
off from the guide pin of the LD Roller Shaft.
Guide Pin
Positioning Hole
LD Roller Shaft
3. Check if the Clutch tooth is not damaged.
4. Check if the Clutch is not damaged.
5. Check if the Compression Spring 2.36 does not come off
in the Change Lever.
Change Lever
Compression Spring 2.36
Troubleshooting
Remedy
1. Reassemble the Extension Spring 0.143 in the
Clutch mechanism.
2. Reassemble the positioning hole of the Clutch
on the guide pin of the LD Roller Shaft.
Clutch
3. Replace the ASF Unit with a new one.
4. Replace the ASF Unit with a new one.
5. Replace the ASF Unit with a new one.
Revision B
58