IBM N6270 Hardware And Service Manual page 95

Installing the boot device and transferring system files nondisruptively using
netboot in systems running Data ONTAP 8.0.x or 8.1 for 7-Mode:
You can nondisruptively transfer the system files and restore configuration
information to your HA configuration by using netboot and a the partner node.
Before you begin
Important: This nondisruptive procedure can only be used in an system in an HA
configuration that is running Data ONTAP 8.0.1.
For copying system files to the boot device, you must have the following:
v The blank replacement boot device you received from your provider.
v A network interface to the HA pair partner node.
v A separate IP address to use to netboot the target node.
About this task
The following procedure is written with the assumption that the target node has
been take over by the partner node and that the target node has booted to the
firmware prompt after the takeover has completed.
Procedure
1. Download and extract the netboot.tgz file from the IBM N series support
website, which is accessed and navigated as described in "Websites" on page
xxii. This file is used for performing a netboot of your system. Download the
file contents to a web-accessible directory. To download the file, complete the
following substeps:
a. Download the netboot.tgz file from the IBM N series support website to
the web-accessible directory.
b. Change to the web-accessible directory.
c. Extract the contents of the netboot.tgz file to the target directory by
entering the following command: tar -zxvf netboot.tgz
Your directory listing should contain the following directory:
netboot/
2. Download the image.tgz file from the IBM N series support website to the
web-accessible directory. Your directory listing should contain the following
file and directory:
image.tgz
netboot/
3. If you are not already grounded, properly ground yourself.
4. Turn the controller module so that you can locate the boot device enclosure.
Use the FRU map on the controller module to help you locate the boot device
enclosure.
5. Open the boot device cover, if applicable.
6. Align the boot device with the boot device socket or connector, and then
firmly push it into the socket or connector.
7. Check the boot device to make sure that it is seated squarely and completely
in the socket or connector, and reseat the boot device, if necessary.
Replacing N6200 series system devices
69