Figure 29. Removing the boot device
3. Open the boot device cover and gently lift the boot device out of the housing.
4. Set the boot device aside.
Installing the boot device in a system running in 7-Mode
After you remove the old boot device, you must transfer system files and restore
configuration information to your replacement boot device using one of several
methods.
Before you begin
Note: For systems running in 7-Mode, it is advised to use the nondisruptive
procedure for HA configurations running Data ONTAP 8.0.1 and later.
v "Installing the boot device and transferring system files nondisruptively using
v "Installing the boot device and transferring system files nondisruptively using
v "Installing the boot device and transferring system files disruptively using
68
IBM System Storage: N6200 Series Hardware and Service Guide
Boot device cover
1
Boot device
2
netboot in systems running Data ONTAP 8.0.x or 8.1 for 7-Mode" on page 69
netboot in systems running Data ONTAP 8.1.1 for 7-Mode" on page 71
netboot in a 7-Mode system" on page 74
2
1