IBM N6270 Hardware And Service Manual page 112

15. At the firmware prompt, enter the following command:
16. Select the Install new software first option from the displayed menu.
17. Enter y when you see the following prompt:
86
IBM System Storage: N6200 Series Hardware and Service Guide
If you...
Do not have DHCP enabled
netboot http://path_to_the_web-accessible_directory/netboot/kernel
The system begins to boot, but stops at the Boot menu.
Please choose one of the following:
(1) Normal Boot
(2) Boot without etc/rc.
(3) Change password.
(4) Clean configuration and initialize all disks.
(5) Maintenance mode boot.
(6) Update flash from backup config.
(7) Install new software first.
(8) Reboot node.
Selection (1-8)? 7
This menu option downloads and installs the new Data ONTAP image to the
boot device.
Note: During the software install process, you are prompted for the URL of
the image.tgz file. Enter the path as follows:
http://path_to_the_web-accessible_directory/image.tgz
This procedure will replace existing
Data ONTAP software with new software.
Do you want to continue? {y|no} y
Then...
Enter the following command:
ifconfig e0a -addr=filer_addr
-mask=netmask -gw=gateway -dns=dns_addr
-domain=dns_domain
filer_addr is the IP address of the storage
system.
netmask is the network mask of the storage
system.
gateway is the gateway for the storage
system.
dns_addr is the IP address of a name server
on your network.
dns_domain is the Domain Name System
(DNS) domain name. If you use this
optional parameter, you do not need a fully
qualified domain name in the netboot server
URL; you need only the server's host name.
Note: To netboot the node when your
system running in Cluster-Mode, you can
use the management IP address.
Note: Other parameters might be necessary
for your interface. For details, use the help
ifconfig command at the firmware prompt.